Aerco Modulex E8 Controls Guide Bedienungsanleitung PDF herunterladen (Seite 28)

PR1: 11/30/12 Page 28 of 112

GF-115-C

Modulex E8 Controller and BCM

Operations and Maintenance Manual

OMM-0084_0D

AERCO International, Inc.

•

100 Oritani Dr.

•

Blauvelt, NY 10913

•

Ph: 800-526- 0288

Table 4-3: EXPERT Menu Listing (Continued)

FUNCTION DESCRIPTION ENTRY RANGE DEFAULT

INSTALLATION Sub-Menu

(Continued)

HYSTERESIS

Not Applicable

–

FOUND

MODULS

Displays the number of heat modules available

for service.

Display

CAP/MODULE

Displays the maximum Kw output of each heat

module.

00 – 1000 Kw 40 Kw

NEW CONFIG

Not Applicable

MIN MOD

CASC

Not Applicable 01 – 08 01

HW-BOILER

Not Applicable

00 – 08

CONTR

DEVIAT

Control Deviation indicates the temperature

difference between the Boiler set point and the

actual water temperature.

Display °F

DES OUPUT

Required system output [in %]

0 – 100%

SWITCH TIME

Not Applicable

(N/A)––

(N/A)

BLOCK TIME

Not Applicable

(N/A)

MAX T-

MODUL

Maximum temperature of Heat Module 122.0°F to 230.0°F 194.0°F

DYN

UPWARD

Not Applicable (N/A) (N/A)

DYN

DOWNWARD

Not Applicable (N/A) (N/A)

RESET TIME

Not Applicable

5 – 500

MODULAT

MAX

Start Level. If this modulation percentage is

exceeded, the next heat module is connected

after the delay time elapses.

50% - 100% 30%

MODULAT

MIN

Stop Level. If value drops below this

modulation percentage, the last heat generator

(module) of the current sequence is switched

off

10% - 60% 35%

MIN MOD HS

Not Applicable

0% - 60%

35%

MOD LEVEL

Not Applicable

SEQUENCE 1

Boiler sequence 1 12345678

SEQUENCE 2

Boiler sequence 2

87654321

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 111 112

Kommentare zu diesen Handbüchern

Keine Kommentare

Aerco Modulex E8 Controls Guide Bedienungsanleitung Seite 28

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Ausrüstung Aerco Modulex E8 Controls Guide